LIGHTING SYSTEM · 8

LIGHTING SYSTEM · 8

1989-Mitsu-Factory Manual · lighting system · страница 8 из 8 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 8

LIGHTING SYSTEM -

SERVICE POINTS OF REMOVAL

1. HAZARD WARNING SWITCH

Insert the trim stick into the switch and pry the switch to
remove it from the instrument panel.

Иллюстрация 2, страница 8
Иллюстрация 3, страница 8

Проверка

Operate the swtich and check the continuity between the
terminals.

l\Terminal 1 I I I I I I I I I IIndi-! I

Иллюстрация 4, страница 8
Иллюстрация 5, страница 8

NOTE

I

16Wl604

O-O Indicates that there is continuity between the
terminals.

DIMMER CONTROL SWITCH

REMOVAL AND INSTALLATlON

Иллюстрация 6, страница 8
Иллюстрация 7, страница 8
Иллюстрация 8, страница 8
Иллюстрация 9, страница 8
Иллюстрация 10, страница 8

Removal steps
1. Knob

2. Ring nut

3. Dimmer control switch

NOTE
Reverse the removal procedures to reinstall.

16W936

INSPECTION
(1) Measure the continuity between the dimmer control
switch terminals with an ohmmeter.
(2) If the resistnace value varies smoothly between 0 and
100 throughout the entire operation range, the dimmer
control switch is functioning properly.

Иллюстрация 11, страница 8

16F68

Оригинальная страница руководства
8-202 LIGHTING SYSTEM - Hazard Wiring Switch/Dimmer Control Switch
100%

Назад
Сверху