1989-Montero · cooling system · страница 15 из 18 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL
1. REMOVAL OF AIR INTAKE PLENUM
Refer to GROUP 11 - Air intake plenum.
2. DISCONNECTION OF FUEL HIGH PRESSURE HOSE
Caution
Cover fuel pipe line with rag after relieving pressure as
certain pressure may still remain.
6. REMOVAL OF DELIVERY PIPE, FUEL INJECTOR AND
PRESSURE REGULATOR
Remove delivery pipe with fuel injector and pressure
regulator.
Caution
Do not drop injector when removing delivery pipe.
22. REMOVAL OF INTAKE MANIFOLD
Refer to GROUP 11 - Intake manifold.
Проверка
hW”CAB
Насос охлаждающей жидкости
l Check each part for cracks, damage or wear, and replace
the water pump assembly if necessary.
l Check the bearing for damage, abnormal noise and
sluggish rotation, and replace the water pump assembly if
necessary.
l Check the seal unit for leaks, and replace the water pump
assembly if necessary.
l Check for water leakage if water leaks from hole “A” seal
unit is faulty. Replace as an assembly.
NrmmAC
SERVICE POINTS OF INSTALLATION
27. INSTALLATION OF O-RING/26. WATER PIPE ASSEM- BLY
insert the O-ring to the water inlet pipe, and coat the outer
circumference of the O-ring with water.
By coating with water, the insertion to the water pump will
become easier.
Caution
Care must be taken not to permit engine oil or other
greases to adhere to the O-ring.
22. INSTALLATION OF INTAKE MANIFOLD
Refer to GROUP 11 - Intake manifold.
1. INSTALLATION OF AIR INTAKE PLENUM
Refer to GROUP 11 - Air intake plenum.
Оригинальная страница руководства
