SERVICE ADJUSTMENT PROCEDURES · 8

SERVICE ADJUSTMENT PROCEDURES · 8

1989-Mitsu-Factory Manual · meters gauges · страница 8 из 16 · Открыть оригинал PDF ↗

SERVICE ADJUSTMENT PROCEDURES

SPEEDOMETER INSPECTION NwilAFa

NOTE

if there is a special regulation for speedometer -indicator
difference in the area where the vehicle is operated, be sure
to meet the requirement of the regulation.

(1) Adjust tire inflation pressure to the standard value. (Refer
to GROUP 22 - General Specifications.)
(2) Use speedometer tester to check indicator difference.
Caution

When checking with speedometer tester, block
nonoperating wheels to prevent vehicle moving.

TACHOMETER INSPECTION <2.6L Engine> ~08nm~
Connect a tachdwell meter, and then compare the meter
readings at various engine speeds with the values indicated
on the tachometer.

Standard value:
1,000 rpm flO0 rpm
3,000 rpm +I50 rpm
5,000 rpm +250 rpm

Caution

The tachometer is the negative-ground type, and there-
fore should not be connected in reverse polarity to the
battery. If the tachometer is connected in reverse polar-
ity, the transistors and diodes will be damaged.

Иллюстрация 1, страница 8

(2) Connect a tachodwell meter to paper clip. Compare the
tachodwell meter reading with the tachometer reading at
each engine speed and check that the error is within the
standard value.

Standard value:
1,000 rpm +I00 rpm
3,000 rpm *I50 rpm
5,000 rpm 5250 rpm

Caution

evision

The tachometer is the negative-ground type, and
therefore should not be connected in reverse to the
battery. If the tachometer is connected in reverse,
transistors and diodes will be damaged.
1

Оригинальная страница руководства
-__..- .._
100%

Назад
Сверху