1991-Montero-Service-Manual · Система круиз-контроля — страница 18

CIRCUIT TESTS (1992) · 18

1991-Montero-Service-Manual · Система круиз-контроля · страница 18 из 28 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 18
Иллюстрация 2, страница 18
Иллюстрация 3, страница 18
Иллюстрация 4, страница 18
Иллюстрация 5, страница 18
Иллюстрация 6, страница 18
Иллюстрация 7, страница 18
Иллюстрация 8, страница 18
Иллюстрация 9, страница 18
Иллюстрация 10, страница 18
Иллюстрация 11, страница 18
Иллюстрация 12, страница 18
Иллюстрация 13, страница 18
Иллюстрация 14, страница 18
Иллюстрация 15, страница 18
Иллюстрация 16, страница 18
Иллюстрация 17, страница 18

Fig. 21: 1991 Acturator Connector
Courtesy of Mitsubishi Motor Co.

CIRCUIT TESTS (1992)

NOTE: To identify circuit connector terminals, See Figs. 22-29.
For wiring diagram, See appropriate chassis wiring diagram in
the WIRING DIAGRAMS Section.

Test No. 1 (Power & Ground Circuit)

1) Turn ignition on. When cruise control main switch is
turned to ON position, battery voltage should be present on terminal
No. 2 of cruise control unit connector.

2) If voltage is not present, check fuse No. 11 and replace
as necessary. If fuse is okay, check and repair harness as necessary.
Terminal No. 8 should be grounded at all times. If terminal No. 8 is
not grounded, repair harness.

Test No. 2 (Set Switch Circuits)

When set switch is turned to ON position, 3 volts should be
present on terminal No. 18 of cruise control unit. When set switch is
turned to OFF position, voltage should not be present on terminal No.
18 of cruise control unit. If circuit does not test correctly, replace
switch as necessary or repair harness.

Test No. 3 (Resume Switch Circuit)

When resume switch is turned to ON position, 6 volts should
be present on terminal No. 18 of cruise control unit. When resume
switch is turned to OFF position, voltage should not be present on
terminal No. 18 of cruise control unit. If circuit does not test
correctly, replace switch as necessary or repair harness.

Test No. 4 (Cancel Switch Circuit)

When cancel switch is turned to On position, battery voltage
should be present on terminal No. 18 of cruise control unit. When
cancel switch is in Off position, voltage should not be present on
terminal No. 18 of cruise control unit. If circuit does not test
correctly, replace switch as necessary or repair harness.

Оригинальная страница руководства
Fig. 21: 1991 Acturator Connector
100%

Назад
Сверху