1991-Montero-Service-Manual · tests with codes · страница 4 из 268 · Открыть оригинал PDF ↗
Fig. 2: Diagnostic Fault Chart (2 of 2)
Courtesy of Mitsubishi Motor Sales of America.
DIAGNOSTIC PROCEDURE (USING DRB-II)
DRB-II PROCEDURE
NOTE: When using diagnostic code charts, DO NOT skip any steps in
chart or incorrect diagnosis may result. Always check related
Technical Service Bulletins (TSB’s).
Refer to ENTERING ON-BOARD DIAGNOSTICS (USING DRB-II) to
retrieve fault codes. If fault codes are NOT present and/or DRB-II is
used, proceed to one of the following tests:
* Go to NO START TEST 1 (NS-1) chart if a no-start condition
exists or engine stalls after start-up. Perform indicated
VERIFICATION PROCEDURE chart after repairs. Ensure charts
apply to engine being tested.
* Go to DRIVEABILITY TEST 1 (DR-1) chart if engine runs but has
performance problems. Perform indicated VERIFICATION
Оригинальная страница руководства
