1991-Montero-Service-Manual · starter · страница 6 из 9 · Открыть оригинал PDF ↗
collar should be .02-.08" (.51-2.03 mm) on Mitsubishi starters, when
solenoid is engaged. Adjust as necessary by changing shims between
solenoid and starter yoke.
Fig. 5: Measuring Pinion Gear-to-Pinion Stopper Clearance
Pinion Case Bearing
Inspect bearing for wear and check side play. If clearance
exceeds .008" (.2 mm), replace bearing. New bearing clearance should
be .002-.004" (.05-.10 mm) for Mitsubishi starters.
NOTE: Ensure that bearing is installed so that end of bearing is
flush with gear case end.
REASSEMBLY
To reassemble, reverse disassembly procedure. Fill gear case
on reduction gear models with grease. Lightly oil pinion and all
bearing surfaces.
Оригинальная страница руководства
