Haynes_Manual_for_Montero_1988_and_Pickup_1987 · cooling heat ac · страница 13 из 16 · Открыть оригинал PDF ↗






la Evaporator assembly and related components
(pre-1988 models)
7 Evaporator assembly
2 Sleeve duct
3 Fresh air duct
4 Fresh air cover gasket (right)
5 Fresh air cover (right)
6 Original part
7 Fresh air cover (left)
8 Fresh air cover gasket (lefi)
Q Original part
70 Baffle
11 Cable
12 Clip
13. Duct (right)
14 Center duct
15 Left lower duct
16 Left upper duct
17 Fan and temperature switch
18 Wiring harness
19 Fan knob
20 Temperature knob
21 Thermistor control box
22 Drain clamp
23 Drain hose
24 go-degree elbow
25 Drain restrictor
*
--


6 Remove the mounting bolts from the condenser brackets.
18 Air conditioning system evaporator - removal
and installation
7 Lift the condenser out of the vehicle and plug the lines to keep dirt and
moisture out.
8 If the orfginal condenser will be reinstalled, store it with the line fittings
on top to prevent oil from draining out.
Refer to illustrations 18. la, 18. lb, 18.Qa and 18.Qb
1 The air conditioner evaporator is combined with the heater assembly
andismountedunderthe rightsideofthevehicledashboard(seeiiiustra-
tions).
9 If a new condenser is being installed, pour one ounce of refrigerant oil
into it prior to installation.
10 Reinstall the components in the reverse order of removal. Be sure the
rubber pads are in place under the condenser.
2 Before removing the evaporator, the system must be depressurized
by an air conditioning technician. DO NOT attempt to do this yourself; the
refrigerant used in the system can cause serious injuries and respiratory
irritation.
11 Have the system evacuated, recharged and leak tested by the shop
that discharged it.

