1989-Montero · wheels tires · страница 4 из 6 · Открыть оригинал PDF ↗
SERVICE ADJUSTMENT PROCEDURES
CHECKING TIRE INFLATION PRESSURE -
Check the inflation pressure of the tires.
If it is not within the standard value, make the necessary
adjustment.
CHECKING TIRE WEAR
Measure the tread depth of tires
h!.maAa
Limit : 1.6 mm I.06 in.)
If the remaining tread depth is less than the limit, replace the
tire.
NOTE
531510
When the tread depth of tires is reduced to 1.6 mm (.06 in.) or
less, wear indicators will appear.
NzzFcAc
CHECKING WHEEL RUNOUT
Jack up the vehicle so that the wheels are clear of the floor.
While slowly turning the wheel, measure wheel runout with a
dial indicator.
Limit : Radial 2 mm (.08 in.)
Lateral 2 mm (.08 in.)
If wheel runout exceeds the limit, replace the wheel.
WHEELS AND TIRES
REMOVAL AND INSTALLATION
Removal steps
1. Center cap
2. Hub nut
1)* 3. Center cap holder
4. Balance weight
5. Steel wheel
6
6. Tire
NOTE
NOTE
(I) Reverse the removal procedures to reinstall.
(2) ++ : Refer to “Service Points of instailation”.
I
1 TSB Revision
Оригинальная страница руководства
