Haynes_Manual_for_Montero_1988_and_Pickup_1987 · Электрооборудование автомобиля · страница 6 из 19 · Открыть оригинал PDF ↗
7 With the high beams on, the high-intensity zone should be vertically
centered with the exact center lust below the horizontal line. Note: It may
not be possible to position the headlight aim exactly for both high and low
beams. If a compromise must be made, keep In mind that the low beams
are the most used and have the greatest effect on driver safety.
8 Have the headlights adjusted by a dealer setvice department or ser-
vice station at the earliest opportunity.
12 Bulb - replacement
Refer to illusfrations 12. la, 72. lb, ~12. Ic, 12. Id, 72. le and 12. If
1 The lenses of many lights are held in place by screws, which makes it
a simple procedure to garn access to the bulbs (see illustrations).
2 On some lights the lenses, such as the interior dome light lens, a?e
held in place by clips. The lenses can be removed either by unsnapping
them or by using a small screwdriver to pry them off.
3 Several types of bulbs are used. Some are removed by pushing in&d
turning them counterclockwise. Others can simply be unclipped from the
terminals or pulled straight out of the socket.
4 To gain access to the instrument panel lights, the instrument cluster
will have to be removed first (see Section 15).
13 Wiper motor - removal and installation
Refer to illustration 13.3
7 Remove the negative battery cable from the battery.
2 Unplug the electrical connector leading from the wiper motor, _
3 Remove the three bolts attaching the motorto the vehicle firewaqgee
_~ _
illustration).
4 Pull up on the wiper arm until the actuator arm joint is visible in the
access hole, then pry the motor out of the actuator arm joint with a screw-
driver,
5 Installation is the reverse of removal.
Оригинальная страница руководства
