Montero 1998 Repair Manual · transmission servicing at · страница 2 из 7 · Открыть оригинал PDF ↗
Lubricant level should be to bottom of fill hole on side of
transfer case.
RECOMMENDED FLUID
Transaxle/Transmission
Except Montero, use Diamond ATF SP-II. On Montero, use
Dexron-II ATF.
Transfer Cases
Use SAE 75W-85 gear oil with API GL-4 rating or higher.
FLUID CAPACITIES
TRANSAXLE/TRANSMISSION REFILL CAPACITIES
| Application Qts. (L) |
|---|
| Diamante ................................................. 9.0 (8.5) |
| Eclipse |
| 2.0L Non-Turbo ......................................... 9.1 (8.6) |
| 2.0L Turbo ............................................. 7.1 (6.7) |
| 2.4L ................................................... 6.4 (6.1) |
| Galant ................................................... 6.3 (6.0) |
| Mirage ................................................... 8.2 (7.8) |
| Montero ................................................. 10.4 (9.8) |
| 3000GT ................................................... 7.9 (7.5) |
Таблица в оригинале
TRANSFER CASE REFILL CAPACITIES
| Application Pts. (L) |
|---|
| Eclipse AWD ............................................... 1.0 (.5) |
| Montero .................................................. 5.3 (2.5) |
| Montero Sport ............................................ 4.9 (2.3) |
| 3000GT ..................................................... .6 (.3) |
Таблица в оригинале
DRAINING & REFILLING
NOTE: Although manufacturer recommends changing only fluid, the
oil filter/screen may also require replacement. If replacing
oil filter/screen, note length and location of all bolts.
Transaxle (Except Montero)
1) Remove drain plug(s), and drain fluid. Some models may
contain a drain plug located in housing below axle shaft, in oil pan.
Remove oil pan. Remove oil filter/screen if necessary.
2) If oil filter/screen is replaced, tighten bolts to
specification. See TORQUE SPECIFICATIONS. Clean oil pan, replace
gasket, and install oil pan. Tighten oil pan bolts and drain plug to
specification. See TORQUE SPECIFICATIONS. Ensure dipstick hole area is
clean. Fill transmission with Diamond ATF SP-II, through filler tube,
until COLD level is reached on dipstick.
3) Start engine and allow to idle for 2 minutes. Shift
transaxle to each position, ending in Neutral. Add sufficient fluid to
reach lower mark. After reaching normal operating temperature, fluid
should be between upper and lower marks of HOT range on dipstick.
Transmission (Montero)
1) Remove drain plug (if equipped) from transmission pan, and
allow fluid to drain. On models without drain plug, oil pan must be
Оригинальная страница руководства
