Pajero II Workshop Manual 1998 Supplement · PWJE9086 I PAJERO 98 CHASSIS 15 · страница 5 из 5 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

INSTALLATION SERVICE POINTS

INTAKE MANIFOLD GASKET INSTALLATION

Install the gaskets so that the projections face in the directions
shown in the illustration.

INTAKE MANIFOLD INSTALLATION

Tighten the intake manifold mounting nuts one bank after the
other by the following procedure
Tighten the nuts in the right bank to 7 Nm:

Tighten the nuts in the left bank to 20 to 23 Nm
Tighten the nuts in the right bank to 20 to 23 Nm
Repeat steps (2) and (3) again in the same order:

HIGH-PRESSURE FUEL HOSE INSTALLATION
Apply a drop of new engine oil to the O-ring:
Caution

Be sure not to let engine oil in the delivery pipe:

While turningthehigh-pressure fuel hose to the right and
left, install the delivery pipe, while being careful not to
damage the O-ring:

3.If it does not turn smoothly, the O-ring may be trapped
remove the high-pressure fuel hose and then re-insert it
into the delivery pipe and check once again
Tighten the high-pressure fuel hose to the specified
torque.

Tightening torque: 5 Nm

Проверка

Check the following points; replace the part ifproblem is
found.

Damage or cracking of any part:

Clogging of the negative pressure (vacuum) outlet port, or
clogging of the water orgaspassages:

Оригинальная страница руководства