1998 · CHASSIS ELECTRICAL [54] · страница 2 из 5 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
3Set the distance between the screen and the centre of the
fog lamps as shown in the illustration:
Inflate the tyres to the specified pressures and there
should be no other load in the vehicles other than driver
or substituted weight of approximately 75 kg placed in the
driver's position_
5_Withtheengine running at 2,000 rlmin, aim the fog lamp_
6_Check if the beam shining onto the screen is at the
standard value_
Standard value:
(Vertical direction)
100 mm below horizontal (H)
(Horizontal direction)
Parallel to direction of vehicle travel
NOTE
The horizontal direction is non-adjustable. If the deviation
of the lamp beam axis exceeds the standard value, check
to be sure that themounting location or some other point
is not defective
Caution
When making the aiming adjustment; be sure to mask
those lamps which are not being adjusted.
BULB REPLACEMENT
Remove thefoglamp:
2.Remove the cover:
3.Unhook the spring which secures the bulb and then
remove the bulb.
Caution
Do not touch the surface of the bulb with hands or
dirty gloves: If the surface does become dirty; clean it
with alcoholor thinner; and let itdrythoroughly
before installing:
Оригинальная страница руководства
