Service Bulletins · MSB00E35001E · страница 3 из 4 · Открыть оригинал PDF ↗

4. Remedy the malfunctions indicated by th
diagnosis codes, disconnect the diagnosis code
check harness, and then install the valve relay.
Then turn the ignition switch to ON again t
check the ABS warning lamp. (Refer to P.35-36-
16.) If the lamp indicates a malfunction, th
valve relay system may be detective. (Refer to
P.35-36-14.)

ERASING DIAGNOSIS CODES

<Old>With the MUT-II

Connect the MUT-II to the diagnosis connector (16-
pin), and then erase the diagnosis codes.

Without the MUT-II
Remove the battery cable from the battery (-)
terminal for 10 seconds or more, and the
reconnect the cable.

<New>See next page.

Оригинальная страница руководства