Service Bulletins · MSB98E27001e · страница 5 из 5 · Открыть оригинал PDF ↗
FSNAP RING INSTALLATION
(1) After installing the snap ring, measure the clearance (A)
between the snap ring and the retainer with a thickness gauge,
and check that it is within the standard values.
Standard value (A): 0-0.166 mm
(2) If the clearance exceeds the standard value, change the snap
ring so that the clearance is at the standard value.
| Thickness of snap ring mm | Identification colour |
|---|---|
| 2.17 | |
| 2.01 | Yellow |
| 1.85 | Blue |
| 1.69 | Purple |
| 1.53 | Red |
Таблица в оригинале
GROTOR INSTALLATION
Using the special tool, install the rotor until the standard
dimension between the rotor and the bearing case is obtained.
Standard value (A): 19.4-20.0 mm
<Added>
Оригинальная страница руководства
