1984-Montero · engine 2'6 a · страница 51 из 53 · Открыть оригинал PDF ↗
COMPONENTS
Проверка
Cylinder Block
1. Measure cylinder bore with a cylinder gauge at three
levels in directions of A and B. (3EN060)
Level 1: No. 1 piston ring position with piston at TDC
Level 2: Center of cylinder
Level 3: Bottom of cylinder
2. If cylinder bores show more than specified out-of-round
or taper, or if cylinder walls are badly scuffed or scored,
cylinder block should be rebored and honed, and new
oversize piston and rings fitted.
3. Check for damage and cracks.
4. Check top surface for distortion. If excessive distortion is
evident, grind to minimum limit or replace. (6EN053)
Оригинальная страница руководства
