1987-Montero · prop shaft UV joints a · страница 6 из 8 · Открыть оригинал PDF ↗
(2) With the mating marks in alignment, install the propel-
ler shaft to the companion flange.
Caution
Degrease the thread of the mounting bolts and nuts
before tightening these parts. Otherwise, they could
become loose.
DISASSEMBLY AND REASSEMBLY
NlGGE-
l + Adjustment of journal end play
4* 1. Snap ring
l + 2. Grease nipple
+w l + 3. Journal bearing
l + 4. Journal
NOTE
(1) Reverse the disassembly procedures to reassemble
(2) +e : Refer to “Service Points of Disassembly”.
(3) ~~ : Refer to “Service Points of Reassembly”.
5. Flange yoke
6. Sleeve yoke
SERVICE POINTS OF DISASSEMBLY 1. REMOVAL OF SNAP RING
N16GFAC
(1) Make mating marks on the yokes of the universal joint
that is to be disassembled.
(2) Remove the snap rings from the yoke with snap ring
pliers.
Caution
When disassembling, note the positions of snap
rings so that they may be reinstalled in the same
positions.
3. REMOVAL OF JOURNAL BEARING
(1) Remove the journal bearing from the propeller shaft
yoke with special tool.
Оригинальная страница руководства
