1989-Mitsu-Factory Manual · Система зарядки · страница 16 из 17 · Открыть оригинал PDF ↗
REPLACEMENT OF BRUSH
A brush worn away to the limit is replaced using the
procedure below.
(1) Remove the pigtail solder and take out the old brush and
spring.
(2) Install brush spring and new brush in brush holder.
(3) Insert the brush to where there is a space 2-3 mm
(.079-.I18 in.) between the limit line and the end of the
brush holder.
(4) While maintaining the position of the step, solder the
pigtails to the end of the brush holder.
Оригинальная страница руководства
