1989-Montero · intro troubleshooting mechanical · страница 2 из 30 · Открыть оригинал PDF ↗
To Use This Manual
HOW TO USE THIS MANUAL
CONTENTS
The preceding page contains the GROUP INDEX
which lists the group title and group number.
PAGE NUMBERS
All page numbers consist of two sets of digits
separated by a dash. The digits preceding the dash
identify the number of the group. The digits follow-
ing the dash represent the consecutive page
number within the group. The page numbers can
be found on the top left or right of each page.
LIMIT
Shows the standard for judging the quality of a part
or assembly on inspection and means the maxi-
mum or minimum value within which the part or
assembly must be-kept functionally or in strength.
It is a value established outside the range of
standard value.
incidental operation
rformed before re-
TEXT
Unless otherwise specified, each service procedure
covers all models. Procedures covering specific
models are identified by the model codes, or similar
designation (engine type, transmission type, etc.).
A description of these designations is covered in
this unit under “VEHICLE IDENTIFICATION”.
Диагностика и устранение неисправностей
Troubleshootings are classified into master trouble-
shooting and group troubleshooting and located as
follows:
The master troubleshooting is prepared when the
trouble symptom relates to two or more groups and
given in MASTER TROUBLESHOOTING.
The group troubleshooting guide is prepared for
causes of problems related to that individual group
only; a troubleshooting guide is prepared for each
appropriate group.
| Removal steps : The numbers before part names b correspond to numbers in the il- lustration and indicate the order of removal. Disassemblv steos : The numbers before oat-t I ---I-- names co&pond to num6& in the illustration, and indicate the order of’disassembly. |
|---|
| Installation steps : This is provided if installation cannot be made in the reverse order of “Removal steps”; omit- ted if installation in the reverse order of “Removal steps” is possible. Reassembly steps : This is provided if reassembly cannot be made in the reverse order of “Disassembly steps”: omitted if reassembly in the reverse order |
Таблица в оригинале
SERVICE PROCEDURES
The sewice steps are arranged in numerical order
and attentions to be paid in performing vehicle ser-
vice are described in detail in SERVICE POINTS.
DEFINITION OF TERMS
STANDARD VALUE
indicates the value used as the standard for judging
the quality of a part or assembly on inspection or the
value to which the part or assembly is corrected and
adjusted. It is given by tolerance.
The following abbreviations are used in this manual for classification of model types.
M/T : Indicates the manual transmission, or models equipped with the manual transmission.
A/T : Indicates the automatic transmission, or models equipped with the automatic transmission.
F.B.C. : Indicates the feed back carburetor, or engines equipped with the feed back carburetor.
M.P.I. : Indicates the multi-point injection, or engines equipped witkthe multi-point injection.
2.6 L Engine : Indicates the 2.6 liters (155.9 cuin.) engine, or a model equipped with such an engine.
3.0 L Engine : Indicates the 3.0 liters (181.4 cu.in.) engine, or a model equipped with such an engine.
Оригинальная страница руководства
