Haynes_Manual_for_Montero_1988_and_Pickup_1987 · 20ENGINE · страница 3 из 18 · Открыть оригинал PDF ↗
4.5 Exploded view of the 2.OL valve cover, rocker
arms and camshaft
| 7 | Camshaft sprocket |
|---|---|
| 2 | Breather hose |
| 3 | PCV hose |
| 4 | Oil filler cap |
| 5 | Oil filler cap seal |
| 6 | Valve cover bolt seal |
| 7 | Valve cover |
| 8 | Gasket |
| 9 | Semi-circular seal |
| 10 | Camshaft oil seal |
| 11 | Rocker arm assembly |
| 12 | Hydraulic lash ao’juster |
| 13 | Camshaft |
Таблица в оригинале
ommended because of the cleaning and preparation work that must be
done to the components involved.
3 Top Dead Center (TDC) for number 1 piston - locating
This procedure is essentially the same as for the 2.6L engine. Refer
to Part A, Section 3 and follow the procedure outlined there.
| 4 | Valve cover - removal and installation |
|---|---|
| Refe | r to illustrations 4.3 and4.5 |
| 1 | Disconnect the negative cable from the battery. |
| 2 | Remove the aircleaner assembly (see Chapter 4). |
| 3 | Detach the spark plug wires and cable brackets from the valve cover |
Таблица в оригинале
(see illustration).
4 Clearly label and then disconnect any emission hoses and cables
which connect to or cross over the valve cover.
5 Remove the valve cover bolts (see illustration) and lift the cover off.
If the cover sticks to the cylinder head, tap on it with a soft-face hammer or
place a block of wood against the cover and tap on the wood with a ham-
mer.
6 Thoroughly clean the valve cover and remove all traces of old gasket
material.
7 Install a new gasket on the cover, using RTV to hold it in place. Place
the cover on the engine and install the cover bolts. Note: Be sure to install
a newsemi-circularseal(see illustration 4.5) into thecylinderhead. Ap-
plyasmallamountofsealantto thebottomofthesealand,afterithasbeen
installed, to the top of the seal, at the seal-to-head joint.
8 Tighten the bolts to the torque listed in this Chapter’s Specifications.
The remaining steps are the reverse of removal. When finished, run the
engine and check for oil leaks.
Оригинальная страница руководства
