Pajero II Workshop Manual 1991 · Передняя подвеска · страница 17 из 28 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

6DISCONNECTIONOFUPPERBALLJOINTAND
KNUCKLE

Using the special tool, disconnect the upper arm ball joint
fromtheknuckle

Caution

Besure to tie the cord of the special tool to the
nearbypart

2.Loosenthe nut but do not remove it:

Проверка

E33GCAE

UPPERBALL JOINT STARTING TORQUE CHECK
Measurethe upper ball joint startingtorque byusing
special tools.

Standard value: 0.8-3.5 Nm (8-35 kgcm, 7-30 in.Ibs )
If the upper ball joint starting torque is out of specification,
replace the upper ball joint

BALL JOINT DUST COVER REPLACEMENT

Remove the dust cover.

2 .Apply multipurposegrease toboththe interior of dust
cover and the upper ball joint:

SERVICE POINT OF INSTALLATION

12. INSTALLATION OF UPPER ARM

<Vehicles built from November, 1993>

Install the upper arm so that the OUTmark on the upper
arm shaft isfacing towards the outside of the vehicle.

Оригинальная страница руководства