Pajero II Workshop Manual 1991 · Передняя подвеска · страница 27 из 28 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

BALL JOINT DUST COVER REPLACEMENT

(1)Remove the clipringand the dust cover.

(2) Apply multi-purpose grease to the lip and inside f the
dust cover.

(31Use vinyl tape to tape the stabilizer link where shown in
the illustration, and then install the dust cover to the sta-
bilizer link.

(4) Secure the dust cover with the clip ring:
NOTE

When installing the clip ring, align it so that its ends are
located at a 90" angle from the axis of the stabilizer link:

SERVICE POINTS OF INSTALLATION INSTALLATION OF BUSHING

Checkwhich type of busing is being used bytheposi-
tion of the slit, and then install the bushing so that the
slit is in the position shown in the illustration.

INSTALLATION OF STABILIZER BAR BRACKET

3

Position the stabilizer bar so that the marking on the sta-
bilizer bar andtheedge of the bracket becomes the ref-
erence value,andthen tighten the stabilizer bar bracket
mounting bolt.

Reference value:Approx: 10 mm (0.4 in.)

Mitsubishi Motors CorporationDoc. 1993

PWJE9086-€

Оригинальная страница руководства