MANUALS · LUBRICATION [12] · страница 7 из 14 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

OIL LEVEL WARNING SYSTEM INSPECTIONE12FDAA
(1)Check that the proper amount of oil hasbeen filled_

(2) When the ignition switch is turned to ON (do not start the
engine) , check that the oil level warning lamp illuminates.
NOTE

If the oil level warning lamp does not illuminate, the cause
is probablya blown lamp, ormalfunction in the relay.

(3) When the engine is started, check that the oil level warning
lamp turns off

If the oil level warning lamp will not go out, disconnect the
connector of the oil level relay and measure the voltage of
the No.terminal on the harness side of the connector
while idling the engine in order to confirm that it is the same
as the battery voltage.

NOTE

If the voltage at the connector is the same as the battery
voltage, the problem is probably a malfunction of either the
oil level relay or the oil level sensor:If the voltage at the
connector is lower than the battery voltage, the problem is
probably a malfunction of either the alternator or the wiring
harness_

(4) Disconnect the oil level sensor connector. Check that the oil
level warning lamp illuminates after approximately 20
seconds_

If the oil level warning lamp does not illuminate; replace the
oil level relay:

(5) 'Check the continuity between the oil level sensor termi-
nals.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Engine oil tempera- ture	Oil level	Continuity
At 40C (1049F) Or lower	Normal (proper vol- ume)	Continuity
	Low (drained)	Continuity
At 70PC (158*F) higher	Normal (proper vol- ume)	Continuity
	Low (drained)	No continuity

Оригинальная страница руководства