Pajero II Workshop Manual 1998 Supplement · Снижение токсичности отработавших газов · страница 14 из 14 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

EXHAUST GAS RECIRCULATION (EGR) SYSTEM
<4056 Engine>

LEVER POSITION SENSOR (LPS) ADJUSTMENT
[Condition befer adjustment]

Engine coolant temperature 8095*C
Loosen the accelerator cable tension sufficiently

(2)Connect the special tool to the lever position sensor
connector shown in the figure. For 3-pin connector use
MD998478, for 4-pin connector use MD998464_

(3) Connectdigital-type voltmeter between the red clip
(output) and blue clip (earth) of the connected special
tool,

Turnthe ignition switch to ON. (Do not start the engine.)
Measure the output voltage of the lever position sensor
Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Lever condition	Voltage V
Idle position	0.8 1.0
Fully open	3.7 - 5.0

(6) If the voltage is outside the standard value, adjust by
loosening the lever position sensor mounting screw and
turning the lever position sensor body: After adjusting;
securely tighten the screw:

NOTE

The output voltage will increase if the lever position
sensor body is turned in an anti-clockwise direction.

Turn the ignition switch to "OFF"
Adjust the accelerator cable play:

Оригинальная страница руководства