1987-Montero · Body a · страница 15 из 81 · Открыть оригинал PDF ↗
SERVICE ADJUSTMENT PROCEDURES ADJUSTMENT OF HOOD FIT N23FAAC
N23FAAC
‘l. Adjust the fit of hood with the hood adjusting bolts, hood
latch adjusting bolts and hood bumper while they are
installed. Loosen the hood adjusting bolts and adjust the
hood laterally with reference to the hood latch.
2. After lateral adjustment of hood, adjust the hood vertically
with the hood adjusting bolts and hood latch adjusting
bolts.
Make sure that the hood hook is properly engaged with the
hood latch.
NOTE
Apply chassis grease to the sliding portion, the rotating
portion and the spring of the hood latch.
3. Turn the hood bumper and adjust the vertical position of
the hood by adjusting the hood bumper either up or down.
P
, II
ADJUSTMENT
FIT
OF FUEL FILLER DOOR HOOK.
Loosen the fuel filler door hook mounting screws and move
the fuel filler door hook to the left and right so that the door is
flush with the body.
’
ADJUSTMENT
OF DOOR INSTALLATION
N23FEAC
1. Use the special tool to loosen the hinge mounting bolts on
the body side, and then adjust so that the clearance
around the door is uniform on all sides.
Caution
Attach protection
tape to the fender edges near the
place where the hinge is installed.
rSTB Revision
Оригинальная страница руководства
