1987-Montero · Body a · страница 19 из 81 · Открыть оригинал PDF ↗
REMOVAL
(1) Remove or disconnect the following - parts:
0 Air filter
0 Accelerator cable
0 Vapor hose
0 Heater hoses
| 0 | Brake booster vacuum hose |
|---|---|
| 0 | Starter motor wiring harness |
| 0 | Alternator wiring harness |
| 0 | Engine ground (on body side) |
| 0 | Steering shaft joint |
| 0 | Fuel cut solenoid valve connector |
| 0 | E.S.S. solenoid valve connector |
| 0 | High-tension cable |
| 0 | Water temperature gage connector |
| 0 | Power steering pump |
| 0 | Oil pressure switch harness |
| 0 | Transmission oil cooler |
| 0 | Radiator assembly |
| 0 | Oxygen sensor connector |
| 0 | Hydraulic clutch hoses |
| 0 | Brake pipes |
| l | Speedometer cable (transmission side) |
| 0 | Carburetor control wiring harness |
| 0 | Air temperature sensor connector |
| 0 | Water temperature sensor connector |
| 0 | Backup light switch connector |
| 0 | 4WD indicator light switch connector |
| 0 | Pulse generator connector |
| 0 | Fuel pipe |
| 0 | Filler hose protector |
| 0 | 2-way va Ive |
| 0 | Rear combination light connector |
| 0 | Filler neck |
| 0 | Transmission gearshift lever |
| 0 | Transfer gearshift lever Pki bk bl |
| 0 0 | arng rae cae Ft d t |
| 0 | ron an rear seas Door opening trim |
Таблица в оригинале
(2) After removing the body mounting bolts and the body
shims, insert wood blocks into the body and gently lift with
a crane.
Caution
Hoist the body carefully after assuring that all the
connections between body and frame and engine are
separated.
Sling wires with a suitable bar or frame used and with
good protection made by fitting coverings at necessary
points.
Оригинальная страница руководства
