1984 · Сцепление — страница 6

REMOVAL · 6

1984-Montero · clutch a · страница 6 из 11 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 6

REMOVAL

1. Insert a universal clutch alignment tool, or the main drive
gear of transmission in center spline to prevent dropping
of clutch disc.

2. Loosen bolts that hold clutch cover assembly diagonally
one by one and remove clutch cover assembly.

Caution
DO NOT clean clutch disc or release bearing with cleaning
solvent.

Иллюстрация 2, страница 6

INSPECTION

Clutch Disc

Check facing for wear. Replace excessively worn facing. Wear
is measured from facing surface to rivet head. (6CLOO3)

Clutch disc (rivet sink) [Service limit] . . . . . . . . . .
0.3 mm (.012 in.)

Иллюстрация 3, страница 6
Иллюстрация 4, страница 6
Иллюстрация 5, страница 6

Clutch Cover Assembly

Inspect diaphragm spring for excessive wear of fingers and
looseness of strap rivets, and inspect pressure pla.te for scor-
ing. Replace if damage is evident.
Release Bearing and Release Fork

1. Check the release bearing for rough rotatio:n or abnor-

mal noise. Check the diaphragm spring contacting por-
tions for abnormal wear.

2. Check the bearing and fulcrum cbntacting portions of the
release fork for abnormal wear.

Иллюстрация 6, страница 6
Оригинальная страница руководства
REMOVAL
100%

Назад
Сверху