1989-Mitsu-Factory Manual · cooling system · страница 12 из 18 · Открыть оригинал PDF ↗
5. REMOVAL OF ALTERNATOR DRIVE BELT
Vehicles without an air conditioner
Loosen the alternator brace bolt and the alternator support
nut, and then remove the alternator drive belt.
Vehicles with an air conditioner
(1) Loosen the bolt holding the alternator and then loosen
the alternator support nut.
(2) Loosen the bolt for deflection adjustment, and then
remove the alternator drive belt.
INSPECTION NO’IMLlAH
Насос охлаждающей жидкости
l Check each part for cracks, damage or wear, and replace
the water pump assembly if necessary.
l Check the bearing for damage, abnormal noise and
sluggish rotation, and replace the water pump assembly if
necessary.
0 Check the seal unit for leaks, and replace the water pump
assembly if necessary.
l Check for water leakage. If water leaks from hole “A” seal
unit is faulty. Replace as an assembly.
SERVICE POINTS OF INSTALLATION NV
IO. INSTALLATION OF WATER PUMP
Water pump7nstallation bolt size are different and caution
must be paid to ensure that they are properly installed.
| I No. | I Hardness category (Head mark) | dx/mm (in.) | Torque Nm (Wbs.) I |
|---|---|---|---|
| 1 | CT-- | TX 23 (.31 x .90) | - |
| 2 | c9 | 8x28(.31 x1.10) | 12-15 |
| 3 | 0 | 8 x 88 (.31 x 3.46) | D-10) |
| 4 | CT | 8 x 78 (.31 x 3.07) |
Таблица в оригинале
l ADJUSTMENT OF POWER STEERING OIL PUMP DRIVE
BELT DEFLECTION
Refer to GROUP 19 - Service Adjustment Procedures.
l ADJUSTMENT OF ALTERNATOR DRIVE BELT DEFLEC-
TION
Refer to P.7-5.
. ADJUSTMENT OF AIR CONDITIONER COMPRESSOR
DRIVE BELT DEFLECTlON
Refer to GEOUP 24 - Service Adjustment Procedures.
3evision
Оригинальная страница руководства
