1991-Montero-Service-Manual · 3.0l v6 · страница 23 из 40 · Открыть оригинал PDF ↗
2) Inspect camshaft and distributor gear for damage. Measure
camshaft end play, journal diameter and lobe height. Replace camshaft
if it is not within specification. See CAMSHAFT (SOHC) table under
ENGINE SPECIFICATIONS at end of article.
3) Coat components with oil. Reassemble rocker arms, springs
and bearing caps. Install bearing caps with identification number
toward camshaft sprocket. Ensure oil holes and notch of shafts are
properly positioned. See Fig. 19.
ROCKER ARM & SHAFT SPECIFICATIONS TABLE (SOHC)
Application In. (mm)
Oil Clearance ................. (1).0004-.0016 (.010-.041)
Rocker Arm I.D. ............................ .7444 (18.91)
Rocker Arm Shaft O.D. ...................... .7440 (18.90)
Spring Free Length ......................... 2.173 (55.19)
(1) - Maximum clearance is .0039" (.099 mm).
Fig. 20: Installing Rocker Arm Shafts (SOHC)
Courtesy of Mitsubishi Motor Sales of America, Inc.
Installation
1) Coat camshaft with oil, and install in cylinder head.
Оригинальная страница руководства
