1991-Montero-Service-Manual · drive axle front · страница 3 из 10 · Открыть оригинал PDF ↗
Fig. 1: Front Drive Axle & Suspension
Courtesy of Chrysler Motors.
INNER SHAFT & BEARING R & I
REMOVAL
1) Remove right drive axle. See DRIVE AXLES R & I in this
article. Remove inner shaft from differential carrier. Pry dust seal
from housing tube assembly using a screwdriver if replacement is
required. See Fig. 1.
2) If oil seal replacement is required, remove housing tube.
Using slide hammer, remove oil seals. Bend outer area of dust cover
inward on inner shaft. Press bearing from shaft. Remove dust cover
from shaft.
Проверка
Inspect inner shaft for damaged splines or threads. Inspect
bearing for roughness or damage. Measure shaft O.D. Replace shaft if
not within specification. See INNER SHAFT SPECIFICATIONS table.
Оригинальная страница руководства
