1991-Montero-Service-Manual · system component tests · страница 10 из 18 · Открыть оригинал PDF ↗
MOTORS
ISC Motor
See IDLE CONTROL SYSTEM.
RELAYS
NOTE: For internal wiring diagram of MPI control relay, see
appropriate L - WIRING DIAGRAMS article in the ENGINE
PERFORMANCE Section.
MPI Control Relay (Montero, Pickup 3.0L & Ram-50 3.0L)
1) MPI control relay is located near right kick panel. Check
for battery voltage at terminal No. 10 of relay connector. See Fig. 9.
If battery voltage is present, go to step 3). If battery voltage is
not present, check circuit between relay and battery, including
fusible link No. 1.
Fig. 9: MPI Control Relay Connector Term. ID (10 Pin)
Courtesy of Mitsubishi Motor Sales of America.
2) Apply battery voltage to terminal No. 10. Battery voltage
should not be present at terminals No. 4 and 5. Apply battery voltage
to terminal No. 10, and ground terminal No. 8. Battery voltage should
now be present at terminals No. 4 and 5.
3) Apply battery voltage to terminal No. 3. Battery voltage
should not be present at terminal No. 2. Apply battery voltage to
terminal No. 3, and ground terminal No. 7. Battery voltage should now
be present at terminal No. 2.
4) Apply battery voltage to terminal No. 9. Battery voltage
should not be present at terminal No. 2. Apply battery voltage to
terminal No. 9, and ground terminal No. 6. Battery voltage should now
be present at terminal No. 2. Replace relay if it does not test as
specified.
MPI Control Relay (Pickup 2.4L & Ram-50)
1) MPI control relay is located near right kick panel. Check
for battery voltage at terminal No. 4 of relay connector. See Fig. 10.
If battery voltage is present, go to step 3). If battery voltage is
Оригинальная страница руководства
