Pajero II Workshop Manual 1998 Supplement · ENGINE <6G7> · страница 6 из 25 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

(8) If the basic ignition timing is outside the standard value
inspect the MPI system while ref erring to GROUP 13A
Troubleshooting

drivingcancel

(9) Press the MUT-II clear key (Select a forced
mode) to release the Actuator test.
Caution

forced driving will
If the test is not cancelled,continue for 27 minutes: Driving under this condition
may damage the engine

(1O)Check that ignition timing is at the standard value
Standard value: approx: 158 BTDC
NOTE

Ignition timing is variable within about70even
under normal operating
And it is automatically further advancedbyabout 59
from standard value at higher altitudes.

IDLE SPEED INSPECTION

(1) Perform inspectionwith the vehicles in the following
condition.

Engine coolant temperature: 80958C
Lights and all accessories: OFF

Transmission: Neutral (P range for vehicles with
automatic transmission)

(2) Turn the ignition switch to OFF and connect the MUT-II to
the diagnosis connector:

(3)Check the basic ignition timing: Adjust if necessary:
Standard value: 59 BTDC + 39

Run the engine at idle for 2 minutes.

(5)Check the idle speed.Select item No.22 and take
reading of the idle speed:

Curb idle speed: 700 + 100 rlmin

NOTE

The idle speed is controlled automatically by the idle
speed control (ISC) system:

(6) If the idle speed is outside the standard value, check the
MPI componentsby referringtoGROUP13A
Troubleshooting:

Оригинальная страница руководства