1996 · BODY [42] · страница 7 из 16 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SLIDING FORCE OF SUNROOF MOTOR'S CLUTCH CHECK

Insert the sunroof wrench of the on-board tools into the
hexagonal hole in the motor drive shaft;, and hook a spring
balance as shown in the illustration:

Apply battery voltage between terminals (1) and (2) of the
sunroof motor connector to operatethemotor,
3.Measure the load on the spring balance at the point where
the rotation torque of the motor matches the spring force
ofthespring balance:

Standard value: 29-59 N

Caution

The spring balance should be kept a right angle to the
sunroof wrench:

2Ifwrench other than that in the on-board tools is
used;the value for the clutch sliding force willbe
different, s0 only the on-board tool should be used.

If the clutch sliding force is outside the standard value;
turn the motor adjuster to adjust it.

SUNROOF MOTOR CHECK

Check the direction of rotation of the drive gear when the
battery is connected to the connector:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Battery connection terminal	Drive gear rotation direction
	Left
	Right

LimiT SWITCh CONTINuiTy CHECK

Remove the limit switches from the sunroof motor, and
then check the operation of the limit switches.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Switch		Terminal No.
Limit switch A	ON OFF
Limit switch	ON OFF

Checkthe identificationcoloursTheninstallthe limit
switches as shown in the illustration:

Оригинальная страница руководства