1996 · BODY [42] · страница 16 из 16 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
Проверка
HOw TO REPLACEA BATTERY OF THE
TRANSMITTER
Remove the set screw to remove the battery from the
transmitter:
2.Installbattery with its (+) side face-down:
Battery required for replacement: Coin type battery
CR2032
3Insert the claw first; and withcarenot to displace the
O-ring; assemble the transmitter:
Check to see if the keyless entry system operates
NOTE
(1) Do not let water or dust stick totheinsideof the
transmitter when its openAlso, donot touchthe
precision electronic device.
(2) if the O-ring is displaced during the assembly of the
transmitter;water or dust penetrates in it, causing
trouble.
How To REGISTERASECRET CODE
Sincethetransmitterismemorizedbyeach
individual code, it is necessary to registera code
onEEPROM inthe keylessentryreceiver ECU
if thetransmitter or keyless entry receiver ECU
is replaced;or cause Of the trouble is presumed
to be due to faulty registration of the code. Since
two different codes at the most can be memorized
in the memory space of EEPROMthe old code
will becomeunable tobeusedif the following
registration operation is repeated twice. Meanwhile
registera code after confirming that an ordinary
door lockfunctioncanbeworked throughkey
operation.
Connect the MUT-II to the diagnosis connector
(16 pin:)
NOTE
Terminal (1) of the diagnosis connector will be
earthed at this time and the mode will switch
tothesecretcoderegistration preparation
mode
Caution
Connection and disconnection of the MUT-II
shouldalwaysbecarriedoutwiththe
ignition switchin the OFF position:
2Close all of the doors:
After pressing anyswitchon the transmitter
once, and then press it two more times within
10secondsThesecretcodewillthenbe
registered:
5_After registration is completed,the doors will
lock and then unlock once:
NOTE
If there are two transmitters, register the secret
code for the first one, and then within one minute
after doing this, register the secret code for
thesecondonebyfollowingthesame
procedure as given above
After registration for the second transmitter has
been completed, the doors will lock and then
unlock once.
The registrationmodewillbe cleared under
any of the following conditions
After the secret codes have been registered
for two transmitters
After one minute elapses since registration
mode was set
IftheMUT-II is disconnected (if the earth
connection is broken)
If the ignition switch is turned to ON
If any of the doors are opened
3-Turn the ignition switch to ACCand then to
OFF
NOTE
The doors will lock and then unlock at this time,
and themodewill then switchtothesecret
code registration mode
Оригинальная страница руководства
