MANUALS · BODY [42] · страница 16 из 52 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SERVICE POINTS OF REMOVAL
REMOVAL OF WINDSHIELD SIDE MOULDING (LH)/2
WINDSHIELDSIDEMOULDING(RH)/4.WINDSHIELD
UPPER MOULDING
Removeby usingthe specialtoolto leverouteach
moulding:
Caution
Mouldings that become warped should not be re-used,
7.REMOVALOF WINDSHIELD GLASS
(1) In order to protect the body (paint surface), apply cloth
tape to all body areas around the installed windshield
glass
(2)Usingsharp-point drill, make a hole in the windshield
glassedhesive.
(3) Pass piano wire from the inside of the vehicle through
the hole
(4) Pullthepianowire alternatelyfromtheinside and
outside along the windshield glass to cut the adhesive.
Caution
Donot let the piano wire touch the edge of the
windshieldglass:
(5)Make mating marks on the windshield glass and body.
(6) Use the special tool to remove the windshield glass.
Use a knife to cut away the remaining adhesive so that
the thickness can be within 2 mm (0.08 in ) around the
entire circumference ofthebody flange.
(8) Finish the flange surfaces so thatthey are smooth
Caution
Be careful not to remove more adhesive than is
necessary:
2Be careful also not to damage the paintwork on
the body surface with the knife. If the paintwork
is damaged, repair the damaged area with repair
paintor anti-rust agent:
(9) When reusingthe glass;
(9) When reusingthe glass;remove theadhesiveand
window spacer chips still adheringtothe window
glass, andclean with isopropyl alcohol.
(10JClean the body side in the same way
Caution
Let the cleaned places stand for 3 minutes or more,
and carry out the next procedures aftertheyhave
dried. Also, do not touch any surface that has been
cleaned:
Оригинальная страница руководства
