MANUALS · BODY [42] · страница 42 из 52 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

CONTROL UNIT

Check for continuity between terminals under the conditions
describedbelow.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Battery_voltage	Terminal
When there is no	current
When there is cu	rrent

NOTE

O indicates that there is continuity between the terminals
(2)indicatesthatthere is continuitywhenthe (+) is
connected to the tester plus terminal, and the (-) is connected
to the tester minus terminal:

(3)-0 indicates terminals to which battery voltage is applied.

SERVICE POINTS OF INSTALLATION 12. INSTALLATIONOFREARDRAINHOSE/11.FRONT DRAIN HOSE

(1) Tie the rope that was used during removal to the end
of the drain hose, and wind tape around it so that there
isno unevenness

2) Pull the rope topullthe drainhose through:

(3)Pull the drain hose until the protruding length from the
grommet isas shownin the figure

(4) Align the rear drain hose (RH) with the body hole with the
marking atthebottom
(Vehicles built from June 1991)

INSTALLATION OF MOTOR ASSEMBLY

When replacing the motor assembly, open the sunroof
glass approximately 200 mm (7.9 in.), set the hole of the
intermittent gear so that it is aligned between the teeth of
themotor assembly transmission gear, and then install
themotor assembly.

Оригинальная страница руководства