MANUALS · BODY [42] · страница 27 из 52 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
9REMOVAL OF CLIP
(1) Usecross-tip (+) screwdriver to push inward the pin (at
the centreof the trim clip) toa depth of aboutmm
(0.08 in.) .
(2) Pull the trim clip outward to remove it:
Caution
Do not push the pin inward more than necessary be-
cause itmay damage the grommet,or the pinmay
fall in, if pushed too far_
SERVICE POINT OF INSTALLATION
9.INSTALLATION OF SCREW OR CLIP
(1) With the pin pulled out, insert the trim clip into the hole
in the trim.
(2) Push the pin inward until the pin's head in flush with the
grommet
(3) Check whether the trim is secure_
NOTE
Two types of door panel and door trim are availableIdentify
the type from the table below, and install by the following
procedure
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Type | Type B | |
|---|---|---|
| Door panel | Round hole 8 mm (0.31 in) | Square hole 10x12 mm (0.39x0.47 in,) |
| Door trim | Round hole mm (0.43 in.) | Round hole mm (0.24 in) |
| Securing method | Clip | Cap assembled screw |
When installingthetype B door trim to the typeA door
panel
1)Usedrillorsimilartooltowidenthemounting
holes(6mmdia )thedoortrimto11mmin
diameter.
2)Secure ysing clips
When installing the typeA door trim to the type B door
panel
1)Insert grommetsintothe square mountingholesin
the door panel:
2) Tighten usingblackwashers andscrews,andthen
cover the screws with the caps:
Оригинальная страница руководства
