1998 · ENGINE <6G7> [11] · страница 15 из 26 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

CRANKSHAFT PULLEY REMOVAL

TIMING BELT REMOVAL

Align the timing marks

Loosen the center bolt on the tension pulley to remove the
timing belt:

Caution

Make a mark on the back of the timing belt, indicating
the direction of rotation, so it may be reassembled in
the same direction, if it is to be reused

INSTALLATION SERVICE POINTS AUTO TENSIONER INSTALLATION

(1)If the auto tensioner rod is in its fully extended position,
reset it as follows

1)Keep the auto tensioner level and, in that position,
clamp it in the vise with soft jaws_

2)Push in the rod Iittle by little with the vise until the set
hole A in the rod is aligned with that B in the cylinder:

Caution

The auto tensioner must be placed at a right angle
to the pressing surtace of press or vise:
2.Push in the rod slowly to prevent the push rod
from being damaged.

Оригинальная страница руководства