Pajero II Workshop Manual 1998 Supplement · Кузов · страница 10 из 13 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
REMOVAL SERVICE POINT
POWER WINDOW MOTOR ASSEMBLY
Caution
Be careful when handling the power window motor
assembly; as the force of the spring may cause the wires
to pull out of the drum:
INSTALLATION SERVICE POINTS A ~POWER WINDOW MOTOR ASSEMBLYNINDOW REGULATOR ASSEMBLY
POWER WINDOW MOTOR ASSEMBLY AND WINDOW
REGULATOR ASSEMBLY INSTALLATION PROCEDURE
Connect the power window motor assembly to the
harness connector of body side, and then turn the ignition
switch to the ON position.
Hold the UP side of power window switch for 10 seconds
to drive the power window motor:
NOTE
The motor stops automatically after 10 seconds, and the
limit switch within the power window motor will be reset:
Caution
Do not drive the power window motor assembly until
thedoor window glass installation is completed:
3Turn the ignition switch to the OFF position, and then
disconnect the power window motor assembly from the
harness connector of body side
Align the power window motor drive shaft and the square
hole in the drum while using theguideand the opening in
the motor housing asa reference for the installation
position:
(1)Alignthesquare hole with the drive shaft by sliding
the glass bracket (glass mounting section) or by
turning the drum using a ratchet wrench (with
socket diameter of 12.7 mm).
(2) Support the drum and theguidewith your hand while
turning the drum, otherwise the wires may pull out of
the drum
(3)If the wires pull out of the drum, re-insert them by
following the drum and regulator wire installation
procedure
Оригинальная страница руководства
