Pajero II Workshop Manual 1998 Supplement · Кузов · страница 11 из 13 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

5Align the guide and the opening of the motor housing, and
side the guide into the motor housing while holding the
guideand drum:

Install the metal cover securely to the housing
Caution

Make sure that the metal cover is installed securely
and does not move, in order to stop the drum from
vibrating: If the drum vibrates, the glass may not slide
up and down smoothly; or it may fall down:

DRUM AND REGULATOR WIRE INSTALLATION PROCEDURE

Place the drum,guideand regulator ona work bench as
shown in the illustration.

(1)Place the drum so that the square hole is facing
upward.

2)Place theguideso that the slits are facing upward:
3)Place the regulator so that the glass bracket isfacing
downward. Position the glass bracket so that glass is
in the fully-open position.

Pass the springs over the wires, and then install the
lowering wire to the guide first; followed by theliftingwire .
(Theliftingwire should be on top of the lowering wire )

2

Use some narrow-gauge wire (approx.0.5 mm diameter)
to compress the springs, and tie the narrow-gauge wires
to the slits in the guide.

3

Оригинальная страница руководства