1998 · BODY [42] · страница 11 из 14 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

5.Align the guide and the opening of the motor housing; and
side theguideintothemotor housing while holding the
guide and drum:

6Install the metal cover securely to the housing:
Caution

Make sure that the metal cover is installed securely
and does not move, in order to stop the drum from
vibrating: If the drum vibrates; the glass may not slide
up and down smoothlys or it may fall down:

DRUM AND REGULATOR WIRE INSTALLATION PROCEDURE

Place the drum, guide and regulator ona work bench as
shown in the illustration:

(1)Place the drum so that the square hole is facing
upward:

Place theguideso that the slits are facing upward.
Place the regulator so that the glass bracket is facing
downward: Position the glass bracket so that glass is
in the fully-open position

Pass the springs over the wires, and then install the
lowering wire to theguidefirst; followed by the lifting wire
(Theliftingwire should be on top of the lowering wire:)

3-Use some narrow-gauge wire (approx0.5 mm diameter)
to compress the springs, and tie the narrow-gauge wires
to the slits in the guide.

Оригинальная страница руководства