1984-Montero · brakes a · страница 6 из 29 · Открыть оригинал PDF ↗
SERVICE BRAKE PEDAL INSPECTION. AND ADJUST-
MENT
1. Measure the brake pedal height as illustrated.
If the brake pedal height is not within the standiard value,
adjust as follows.
Pedal height (from top of the pedal to floorboard) A
. ..a................. 191-196 .mm (7.5-7.7 in.)
(1) Move the stop light switch to a position where it’does
not contact the brake pedal arm.
(2) Adjust the brake pedal height by turning the operating
rod with pliers (with $he operating rod lock nut loos-
ened), until the correct clearance is obtained.
(14Y727)
(3) Adjust the stop light switch until the 1 dimension
(between the outer case of the stop light switch and
the brake pedal. arm) agree with the standard value,
and then lock the switch in place with :lock nut.
*’
(Y 14591)
Dimension B . . . . . . . .‘. . . . 0.5-1.0 mm (.02:.04 in.)
2. While the engine is stopped, depress the brake pedal two
or three times. After thus eliminating the vacuum in the
power brake booster, press the pedal down by hand, and
confirm that the amount of movement before. resistance
is met (the free play) is within the standard v,alue range.
Brake pedal free play C . . . . . . 1 @15 mm (.4-.6 in.)
‘-
If the free play is less than the standard value, confirm
that the clearance between the outer case of the stop
light and the brake pedal is within the standard value.
3. Start the engine, depress the brake pedal with approxi-
mately 500 N (110 lbs.) of force, and ineasure the
clearance between the brake pedal and the :floorboard.
(C14101)
Pedal to floorboard clearance D when pedal is ‘de-
pressed [Pedal depressing force of 500 N (110 lbs.)]
. . . . . . . . . . . . . . . . . . . . . . 95 mm (3.7 in.) or more
If the pedal to floorboad clearance is less thaln the stan-
dard value, correct it according to the troubleshooting.
Оригинальная страница руководства
