1984-Montero · brakes a · страница 12 из 29 · Открыть оригинал PDF ↗
3. Remove the piston stopper ring. (14K056)
4. Remove the primary and secondary pistons from the
master cylinder body.
Caution
Do not disassemble the primary and secondary pistons.
5. Remove the check valve cap and check valve case, and
then remove the gasket, the check valves and the check
valve springs.
Проверка
1. Check check valve and *check valve spring for deteriora-
tion.
2. Check gasket for damage.
: I
3. Check inner surface of ,master cylinder body for rust or
scars.
4. Check primary tind secbndary pistons for rusf, scouring,
wear, damage or deteiioration.
5. Check primary and secondary piston springs for deterio-
ration.
6. Check the clearance between master cyljnder inner
diameter and piston outer diameter as follows:
Clearance between Master Cylinder Iruiei Diameter and
Piston Outer Diameter :
(1) Measure of the master cylirider inner diametler at three
different positions (bottom, middle and top) by using a
cylinder gauge. ( 14E 108)
Master cylinder to piston clearance [Service limit]
. . . . . . . * ..,.,,.,,..., ,,*, :*.. 0.15 mm (.006 in.)
(2) If the clear&e .between these inner diameters and the
piston outer diameter is not less than the service limit,
, replace the master cylinder and the piston assembly
as set.
REASSEMBLY ‘.
1. Apply brake fluid to the inner surface of the master cyl-
inder body and to thie entire periphery of the second-
ary and primary pistons..( 14K028)
Recommended brake’ fluid . . . . . . . . . . . . . . . DOT 3
2. , Torque parts to specifications during assembly.
INSTALLATION
’
Bleed tee brake system. (Refer to p. 5-8.)
Оригинальная страница руководства
