1987-Montero · power steering a · страница 10 из 41 · Открыть оригинал PDF ↗
‘: I ._
- Service Adjustment Procedures
MEASURING BALL JOINT END PLAY
NlSFPAA
1. Hold the ball joint with pliers.
2. Set a caliper gauge as shown in left figure and measure
the displacement with the ball stud compressed.
Limit : 1.5 mm (.06 in.)
3. If the measured displacement is over the limit, replace the
ball joint.
NOTE
After adjusting the steering angle, mount the cap onto the
jam bolt so that the edge of the slit side of the cap and the
head of the stop bolt are flush and face in the same
direction, and then pack the head of the stop bolt with the
specified grease.
Specified grease : Multipurpose grease SAE 5310, NLGI
No. 2
Caution
Be sure that the toe-in is properly adjusted before
adjusting the steering angle.
CHECKING STATIONARY STEERING EFFORT,,,,,,,
1. Place the vehicle on a level surface and place the steering
wheel in the straight-ahead position.
2. Set the engine speed to 1,000 r/min.
3. Measure the tangential force with a spring balance by
turning the steering wheel clockwise and counterclock-
wise one and a half turns.
Standard value : 37 N (8.21 Ibs.) or less
4. If the stationary steering effort exceeds the standard value,
check for belt slackness, damage, insufficient oil, air mixed
into oil, collapsed or twisted hoses, etc., and repair if
found.
Оригинальная страница руководства
