1989-Mitsu-Factory Manual · Сцепление · страница 10 из 16 · Открыть оригинал PDF ↗
CLUTCH - Clutch Master Cvlinder and Tube
(2) Connect the clutch hose to the release cylinder at the
stepped portion shown in the illustration.
(3) After tightening the clutch tube flare nut and eye bolt,
check to be sure there is no leakage of the clutch fluid.
3. APPLICATION OF GREASE TO CLEVIS PIN/2. WASHER
Refer to P. 6-7.
DISASSEMBLY AND REASSEMBLY
FmsNA-
I
Disassembly steps
++ 1. Piston stop ring
2. Damper and push rod
+I) I)+ 3. Piston assembly
7. Master cylinder body
NOTE
(I) Reverse the disassembly procedures to reassemble
(2) +e : Refer to “Service Points of Disassembly”.
(3) l)a : Refer to “Service Points of Reassembly”.
SERVICE POINTS OF DISASSEMBLY
1. REMOVAL OF PISTON STOP RING
Remove the piston stop ring.
3. REMOVAL OF PISTON ASSEMBLY
Pull out the piston assembly.
Caution
1. Do not damage the master cylinder body and piston
assembly.
2. Do not disassemble piston assembly.
Проверка
NOWCAB
l Check the inside cylinder body for rust or scars.
l Check the piston cup for wear or deformation.
l Check the piston for rust or scars.
SERVICE POINTS OF REASSEMBLY Ncaow38
6. INSTALLATION OF RESERVOIR BAND
After installing the reservoir, tighten the reservoir band in
the range shown in the-:figure.
-
Оригинальная страница руководства
