1989-Mitsu-Factory Manual · Сцепление · страница 11 из 16 · Открыть оригинал PDF ↗
3. APPLICATION OF CLUTCH FLUID TO PISTON ASSEM-
BLY
Apply specified clutch fluid to the inner surface of the
cylinder and to the entire periphery of the piston assem-
bly.
Specified clutch fluid : Brake Fluid SAE J1703 (DOT3)
CLUTCH RELEASE CYLINDER REMOVAL AND INSTALLATION
NOTE
(1) Reverse the removal procedures to reinstall.
(2) I)* : Refer to “Service Points of Installation”.
(3) q : Non-reusable parts
Проверка
ND6HCPrP
l Check the clutch release cylinder for fluid leakage.
l Check the clutch release cylinder boots for damage.
SERVICE POINTS OF INSTALLATION
NOWOAD
5. APPLICATION OF GREASE TO CLUTCH RELEASE CYL-
INDER
Apply a coating of the specified grease to the contact parts
of the release fork and release cylinder push rod.
Specified grease : MITSUBISHI Genuine Grease
Part No. 0101011 or equivalent
4. CONNECTION OF CLUTCH HOSE
(1) Connect the clutch hose to the release cylinder at the
stepped portion shown in the illustration.
(2) After tightening the eye bolt, check to be sure there is
no leakage of the clutch fluid.
Оригинальная страница руководства
