1989-Mitsu-Factory Manual · Сцепление · страница 14 из 16 · Открыть оригинал PDF ↗
l Visually inspect the cover outef mounting flange for
flatness. It should be free-of nicks, burrs, dents or other
damage.
* The three dowels on the. flywheel should be tight and
undamaged.
The cover stamping should be a snug fit on the dowels.
e if the clutch assembly does not meet these requirements,
it should be replaced.
CLUTCH DISC
(1) The disc assembly should be handled without touching
facings. Replace disc if facings show evidence of grease
or oil soakatie.
(2) Use the caliper gauge to measure the dimension from the
facing surface to the rivet head.
Limit : 0.3 mm (.012 in.)
(3) ii;: measured value is below the limit, replace the clutch
(4) The’hub splines and splines on transmission input shaft
should be a snug fit without signs of excessive wear:
(5) Metallic portions of disc assembly should be dry and clean
and show no evidence of having been hot. Each of the
arched springs between facings should be unbroken and
all rivets should be tight.
SERWCE POINTS OF INSTALLATION NOGGDAJ 3. INSTALLATION OF CLUTCH DISC/2. CLUTCH COVER ASSEMBLY
(I) If there are oils or greases on clutch facing and
pressure plate, throughly wipe away with a dry cloth.
(2) Lightly specified grease clutch disc spline.
Specified grease : MITSUBISHI Gemtine Grease
Part No. 0101011 or equivalent
(3) Using clutch disc guide, or main drive gear of trans-
mission, install clutch disc and clutch cover assembly
on flywheel.
(4) When installing clutch disc, be sure that surface
having manufacturers stamped mark is on pressure
plate side.
(5) When installing the clutch cover assembly, align the
clutch cover assembly’s dowel pin hole and the
flywheel’s dowel pin, and then gradually tighten the
bolts alternately.
1. INSTALLATION OF TRANSMISSION AND TRANSFER
ASSEMBLY
Refer to GROUP 21-Transmission and Transfer Assembly.
Оригинальная страница руководства
