1989-Mitsu-Factory Manual · Сцепление · страница 12 из 16 · Открыть оригинал PDF ↗
GASSEMBLY AND REASSEMBLY
SERVICE POINTS OF DISASSEMBLY
WsLaAA
5. REMOVAL OF PlSTON AND CUP
Remove the piston from the release cylinder using com-
pressed air.
Caution
1. Cover with rags to prevent the piston from popping
Out.
2. Apply compressed air slowly to prevent brake fluid
from splashing.
Проверка
(I) Check the inner surface of the release cylinder for
scratches or irregular wear.
(2) Replace if the piston cup outer circumference is scratched
or shows signs of fatigue, or if there is excessive wear of
the lip where indicated in the figure.
SERVICE POINTS OF REASSEMBLY 5. APPLICATION OF FLUID TO PISTON AND CUP
NOSLOAO
After applying a coating of the specified brake fluid to the
inner surface of the release cylinder body and to the entire
circumference of the piston and cup, insert the piston and
cup into the release cylinder.
Specified clutch fluid : Brake Fluid SAE J1703 (DOT 3)
Оригинальная страница руководства
