1989-Montero · Рулевое управление с усилителем · страница 18 из 40 · Открыть оригинал PDF ↗
SERVICE POINTS OF DISASSEMBLY 7. REMOVAL OF SNAP RING
Using the snap ring pliers, remove the snap ring from
steering shaft A and exttct steering shaft A from the
bottom of steering column A.
NOTE
Release the steering lock to extract steering shaft A.
14. REMOVAL OF SPECIAL BOLTS/%. STEERING LOCK ASSEMBLY
If it is necessan/ to remove the steering lock, cut a groove
on the head of each special bolt with a metal saw, and
remove the steering lock with a screwdriver.
25. REMOVAL OF SPECIAL BOLTW26. PLATE
If it is necessary to remove the plate of steering column B,
cut a groove on the head of each special bolt with a metal
saw, and remove the plate with a screwdriver.
Проверка
Check the plate for cracks or damage.
Check the column bushing for damage.
Check the dash panel cover for damage.
Check the steering shaft bearing for wear.
Check the steering shaft for damage and deformation.
Check the teeth of the plate assembly for wear.
Check the steering shaft joint for play or faulty operation.
Check the dust seal and bushing for damage or unusual
wear.
SERVICE POINTS OF REASSEMBLY
NISGHA”~
38. INSTALLATION OF JOINT ASSEMBLY
(1) Plate the upper boot over steering shaft C assembly and
the lower boot and dust cover over steering shaft D.
NOTE
Leave the upper and lower boots on the shafts without
assembling them to the universal joint.
:I
Оригинальная страница руководства
