1989-Montero · Рулевое управление с усилителем · страница 39 из 40 · Открыть оригинал PDF ↗
REPLACEMENT OF DUST COVER
(I) Remove the dust cover from the tie rod end or the idler
arm.
NOTE
For the idler arm, also remove the O-ring.
(2) Apply the multipurpose grease to the lip portion of the
dust cover.
(3) Use the multipurpose grease inside the dust cover.
(4) Apply the specified sealant to the dust cover installation
surface, and then press in.
Specified sealant : 3M ART Part No. 8863 or equivalent
REPLACEMENT OF IDLER ARM BUSHING NIOVFPIB~
(1) Apply the multipurpose grease to the inside surface of the
bushing and the idler arm support shaft.
(2) Inset-t the bushing into the idler arm.
(3) Insert the idler arm support into the idler arm.
(4) install so that the knurled surface of the washer is facing
the bushing side.
(5) Tighten the self-locking nut at the specified torque.
NWJDAA
SERVICE POINTS OF INSTALLATION
4. INSTALLATION OF TIE ROD ENDS
(1) Apply the specified anti-corrosion agent to the thread-
ed portion of the tie rod end.
(2) Temporarily tighten the tie rod so that the distance
between stud bolts of the tie rod is the value shown in
the figure.
Caution
Tie rod end tightness, left and right, should be
uniform.
(3) Install the tie rod assembly after first confirming which
side is the relay rod side and which side is the knuckle
side.
Оригинальная страница руководства
