1989-Montero · Рулевое управление с усилителем · страница 28 из 40 · Открыть оригинал PDF ↗
(2) Measure the mainshaft starting torque by using the
special tools.
(3) Tighten the top cover until the mainshaft starting
torque is 0.2-0.3 Nm (2-3 in.lbs.) greater than the
previously mentioned measurement value.
NOTE
Tighten the top cover gradually while measuring the
starting torque.
(4) Tighten the valve housing lock nut to the specified
torque by using the special tools.
Caution
Be sure that the top cover does not turn together
with the lock nut at this time.
(5) Measure the mainshaft starting torque by using the
special tool.
Standard value : 0.25-0.65 Nm (25 in.lbs.1
(6) If the measured mainshaft starting torque does not
comply with the standard value, remove the valve
housing lock nut and adjust the tightening of the top
cover.
14. INSTALLATION OF RACK PISTON
Install the rack piston until it comes in contact with the
edge of the mainshaft.
Rotate the mainshaft to align the ball raceway with the ball
insertion hole.
15. INSTALLATiON OF VALVE HOUSING
(1) Apply specified automatic transmission fluid to the
seal ring of the rack piston.
Specified fluid : Automatic transmission fluid DEX-
RON type
(2) insert the valve housing.
(3) Rotate the mainshaft until the rack piston moves to the
neutral position (center).
Оригинальная страница руководства
